5.8.3
CC/CP phase lead/lag mode
When the CC/CP phase lead/lag mode simulates sinusoidal current, the user can set the CC/CP
mode through the panel to adjust the load current or power, and the phase angle range can
be adjusted from 90° to -90°, which simulates inductive and capacitive loads Voltage and
current conditions.
Test steps:
Click "Sequence" to enter the spanel, select the CC/CP mode on the right side of the panel and
set the three-phase current/power parameters and phase angle (Figure 5-21), then click
"Apply" → "Power On" → "Output" On", the power supply starts to run and simulates the
sinusoidal current in phase lead/lag mode.
Figure 5-21 the CC/CP phase lead/lag mode