5.7
Harmonic and inter-harmonic simulation
5.7.1
Harmonic simulation
ESA series provides GUI software, which can edit up to the 50th harmonic.
Test steps:
Click "Sequence Mode" to enter the panel, firstly set the operating parameters (such as output
voltage, frequency). Click "Apply"→"Power On"→"Output On", the power supply is on. Check
the harmonic selection box (Figure 5-15①), click the A/B/C phase harmonic simulation button
(Figure 5-15③), the harmonic setting panel of each order will automatically pop up, then the
user can set the harmonic angle, content and other parameters. After setting the parameters,
check the corresponding boxes and click "Setting" → "Apply" in turn.
To cancel the harmonic simulation, click the A/B/C phase harmonic simulation button (Figure
5-15③), click "Clear" on the pop-up panel to clear all parameters, and then click "Setting" →
"Apply". Finally, uncheck the harmonic selection box.
Figure 5-15 Harmonic Edit-1