Brewer Fitness Treadwall M6 Pro, Owner'S Manual

Page: 47 / 56

43
Treadwall M6 Pro Owner’s Manual—2017
Main Channel Assembly
Each panel has a metal stiffener that
must be mounted on the back (smooth
side) before installing the panel onto the
Treadwall.
Place the panel face down on a piece of
cardboard, line up the stiffy, and press it
into place - stepping on it with your foot if
necessary.
A short round-head "stiffy bolt" is screwed
firmly into the middle hole from the front
The best tools to use for installing panels: A
battery powered electric drill with a #2 Philips bit
and a socket wrench with a 3/8" socket. Do not
overtighten the screws. If your drill has a clutch,
use a low setting so that the head of the screw
seats down but does not dig into the panel.
Notice the plastic wear buttons in the corners of
the panel. The buttons in the front of the panel
should always be at the TOP corners of the panel.
The final hole pattern on the climbing surface
should create a diamond shape. Pay attention
when putting the panels in to alternate between
having a wide or narrow gap between the right
most holes.
After installing the first panel, pull down on the
chains to rotate the panel completely around the
circuit. As it passes the lower shaft, adjust the
sliding sprocket to the proper width so that the
panel passes easily without binding. No set screw
is used for this sprocket.