Brewer Fitness Treadwall M6 Pro, Owner'S Manual

Page: 28 / 56

24
Treadwall M6 Pro Owner’s Manual—2017
Service Instructions
PUMP
ADJUSTMENT BOLT
LOCK NUT
INSPECTION HOLE
Drive Chain Adjustment
1. The drive chain can be adjusted from the
outside of your Treadwall, you only need
to remove the hydraulic box cover on the
top right of the machine.
2. Loosen the locknut on the adjustment
screw, and tighten the screw down onto
the pump. Only make it finger-tight. If the
chain is too tight, the Treadwall will
operate sluggishly.
3. Tighten the locknut and check the chain –
feel it with your finger at the inspection
hole. There should be no slack, but not
too tight.
CAM
PULLEY
CABLE ADJUSTER
Speed Lever Adjustment
1. Adjust the speed lever to the slowest
position.
2. The hydraulic unit is at the top of the right
channel. Remove the cover (two screws).
3. Note the cam and pulley that together
control the valve. With the lever at
slowest position, the pulley should be at
the highest point of the cam. There is a
notch at the highest point that the pulley
fits into.
4. If the pulley is not at the highest position,
tighten the cable with the adjuster.
5. Operate the lever a few times to check
the adjustment. If the wall still creeps
excessively, see the instructions for
adjusting the cam follower.
NOTCH