Brady BMP71, User Manual

Page: 144 / 147

133
Appendix C
BMP71 User’s Manual
Labels (Media) (continued)
Printer will not feed labels. The leading edge of the label roll
is unevent or torn (not a straight
edge). Use a pair of scissors to cut a
straight leading edge on the label
roll.
Label material jams in printer. Last label was not removed. Make sure the last cut label has
been removed from the label tray.
Error - "Out of Media" Label/Media supply is exhausted
1.
Replace label/media roll.
2.
Press [CLEAR/ESC] key to
clear error
Error - "Out of Media" Labels/media are not installed
correctly. Labels/media must be
installed so that they are biased
against the front wall of the lower
printer base. Notch Sensors in the
lower printer base need to detect
the prescence of the labels to allow
printer to operate correctly.
1.
Reinstall labels/media.
2.
Press [CLEAR/ESC] key to
clear error.
(See page 13 for proper label/
media loading.)
Error - "Out of Media" Notch sensors in lower printer
frame are dirty. Notch Sensors in
the lower printer base need to
detect the prescence of the labels
to allow printer to operate
correctly.
1.
Clean sensors in lower printer
base. Press [CLEAR/ESC]
key to clear error.
(See page 32 for proper cleaning
techniques.)
Error - "Out of Media" Label/media memory device has
counted down to zero. Circuit
board on the roll holder core of
label/media contains a memory
device that tells the printer how
much unused material remains on
the label/media supply. Reuse of
the roll holder with memory
device will eventually count down
to zero and give error
1.
Replace label/media or label/
media roll holder.
2.
Press [CLEAR/ESC] key to
clear error.
Error - "No media installed" BMP71 labels/media are not
installed correctly.
1.
Reinstall labels/media.
2.
Press [CLEAR/ESC] key to
clear error.
See page 13 for proper label/
media loading. Verify that circuit
board on core of labels are mating
with contacts in receiver slot of
lower printer base.
Troubleshooting Guide
Problem Cause Corrective Action