AutoDome 800 Series HD PTZ Camera
Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en
25
Bosch Security Systems, Inc.
Installation Manual
F.01U.273.797 | 5.0 | 2012.08
6.
Connect the 3-pin Power In Plug, installed previously, to its matting connector P101 on
the left side of the box.
7.
If installing a Fiber Optic model attach the incoming ST fiber plug, installed previously, to
its mating connector on the Fiber Optic Module in the power supply box. Then attach the
Ethernet cable to its mating connector from the Pendant Connector Harness. See
Section 4 Cable and Wire Standards, page 51
for fiber optic specifications.
Figure 2.11
Optional Fiber Optic Module
8.
Connect the incoming RJ45 connector, installed previously, to its mating connector from
the Pendant Connector Harness. See
Section 4 Cable and Wire Standards, page 51
for
connections and specifications.
9.
Attach the grounding strap of the Pendant Arm to the Power Supply Box. See
Figure 2.10,
Page 24
.
10. After making the harness connections to the Power Supply Box, rotate the Pendant Arm
to close and seal the Power Supply Box and tighten the two (2) captive screws to
10-12 N-m (90-105 in.-lbs).
11. Refer to
Section 2.9 Attach Pendant to Arm and Tighten, page 31
, to continue the
AutoDome Installation procedure.
1
Transformer
5
In/Out
2
Ethernet to Dome
6
ST Connector (Fiber)
3
In/Out
7
Power In
4
From Arm Harness
8
Data In/Out
(GND)
GND TXD
RXD
C+
C-
(FUSE)
(FUSE)
(FUSE
)
24V NC 24V
HTR DOME
NOTICE!
After all wiring is complete, close the cover door and tighten the two (2) captive
screws on the cover door to 10-12 N-m (90-105 in.-lbs) to ensure the Power Supply Box is
watertight.
Summary of Contents for VG5 800 SERIES
Page 1: ...AutoDome 800 Series HD PTZ Camera VG5 800 Series en Installation Manual ...
Page 2: ......
Page 122: ......
