AutoDome 800 Series HD PTZ Camera
Configuring the AutoDome 800 Series | en
109
Bosch Security Systems, Inc.
Installation Manual
F.01U.273.797 | 5.0 | 2012.08
NTCIP
Specifies a set of rules and protocols for organizing, describing and exchanging transportation
management information between transportation management applications and
transportation equipment such that they interoperate with each other.
Select a port for
NTCIP
and the
Address
from the appropriate drop-down lists.
UPnP
You can activate the Universal Plug and Play (UPnP) function. If the function is turned on, the
unit responds to requests from the network and is automatically registered on the requesting
computers as a new network device. For example, access to the unit can then be made using
Windows Explorer without knowledge of the IP address of the unit.
TCP Port
The device can receive data from an external TCP sender, for example an ATM or POS device,
and store it as metadata. Select the port for TCP communication. Select Off to deactivate the
TCP metadata function.
Sender IP address
Enter the IP address of the TCP metadata sender here.
Quality of Service
The AutoDome offers Quality of Service (QoS) configuration options to ensure fast network
response to PTZ data and images. Quality of Service (QoS) is the set of techniques to manage
network resources. QoS manages the delay, delay variation (jitter), bandwidth, and packet
loss parameters to guarantee the ability of a network to deliver predictable results. QoS
identifies the type of data in a data packet and divides the packets into traffic classes that can
be prioritized for forwarding.
Consult with your network administrator for assistance configuring the
Audio
,
Video
,
Control
,
and the
Alarm Video
settings.
7.51
Multicast
In addition to a 1:1 connection between an encoder and a single receiver (unicast), the
AutoDome 800 Series can enable multiple receivers to receive the video signal from an
encoder simultaneously. The device either duplicates the data stream itself and then
distributes it to multiple receivers (Multi-unicast) or it sends a single data stream to the
network, where the data stream is simultaneously distributed to multiple receivers in a
defined group (Multicast). You can enter a dedicated multicast address and port for each
stream. You can switch between the streams by clicking the appropriate tabs.
A special IP address (class D address) must be configured for multicast operation in a
multicast-enabled network.
The network must support group IP addresses and the Internet Group Management Protocol
(IGMP V2). The address range is from 225.0.0.0 to 239.255.255.255.
NOTICE!
To use the UPnP function on a computer, both the Universal Plug and Play Device Host and
SSDP Discovery Service must be active in Windows XP and Windows 7.
NOTICE!
Multicast operation requires a multicast-enabled network that uses the UDP and the Internet
Group Management IGMP protocols. Other group management protocols are not supported.
The TCP protocol does not support multicast connections.
Summary of Contents for VG5 800 SERIES
Page 1: ...AutoDome 800 Series HD PTZ Camera VG5 800 Series en Installation Manual ...
Page 2: ......
Page 122: ......
