AutoDome 800 Series HD PTZ Camera
Configuring the AutoDome 800 Series | en
95
Bosch Security Systems, Inc.
Installation Manual
F.01U.273.797 | 5.0 | 2012.08
Time periods
You can change the names of the recording profiles.
1.
Click a profile and then the
Rename
button.
2.
Enter your chosen name and then click the
Rename
button again.
Activating the Recording
After completing configuration you must activate the recording scheduler and start the
recording. Once recording is underway, the
Recording Profiles
and
Recording Scheduler
pages are deactivated and the configuration cannot be modified.
You can stop the recording activity at any time and modify the settings.
1.
Click the
Start
button to activate the recording scheduler.
2.
Click the
Stop
button to deactivate the recording scheduler. Running recordings are
interrupted and the configuration can be changed.
Recording status
The graphic indicates the recording activity of the AutoDome 800 Series. You will see an
animated graphic while recording is taking place.
7.37
Recording Status
Certain details on the recording status are displayed here for information purposes. You
cannot change any of these settings.
7.38
Advanced Mode: Alarm
7.39
Alarm Connections
You can select how the AutoDome 800 Series responds to an alarm. In the event of an alarm,
the unit can automatically connect to a pre-defined IP address. You can enter up to ten IP
addresses to which the AutoDome 800 Series will connect in sequence in the event of an
alarm, until a connection is made.
Connect on alarm
Select
On
so that the AutoDome 800 Series automatically connects to a predefined IP address
in the event of an alarm.
By setting
Follows input 1
the unit maintains the connection that has been automatically
established for as long as an alarm exists on alarm input 1.
Number of destination IP address
Specify the numbers of the IP addresses to be contacted in the event of an alarm. The unit
contacts the remote stations one after the other in the numbered sequence until a connection
is made.
Destination IP address
For each number, enter the corresponding IP address for the desired remote station.
Destination password
If the remote station is password protected, enter the password here.
In this page, you can save a maximum of ten destination IP addresses and hence up to ten
passwords for connecting to remote stations. If connections to more than ten remote stations
NOTICE!
In the default setting, Stream 2 is transmitted for alarm connections. Bear this fact in mind
when assigning the profile (see
Section 7.19 Encoder Profile, page 80
).
Summary of Contents for VG5 800 SERIES
Page 1: ...AutoDome 800 Series HD PTZ Camera VG5 800 Series en Installation Manual ...
Page 2: ......
Page 122: ......
