108
en | Configuring the AutoDome 800 Series
AutoDome 800 Series HD PTZ Camera
F.01U.273.797 | 5.0 | 2012.08
Installation Manual
Bosch Security Systems, Inc.
Status
The status of the DynDNS function is displayed here for information purposes. You cannot
change any of these settings.
7.50
Advanced
The settings on this page are used to implement advanced settings for the network.
Some changes only take effect after the unit is rebooted. In this case, the
Set
button changes
to
Set and Reboot
.
1.
Make the desired changes.
2.
Click the
Set and Reboot
button. The AutoDome 800 Series is rebooted and the changed
settings are activated.
SNMP
The AutoDome 800 Series supports the SNMP V2 (Simple Network Management Protocol) for
managing and monitoring network components, and can send SNMP messages (traps) to IP
addresses. The unit supports SNMP MIB II in the unified code. If you wish to send SNMP
traps, enter the IP addresses of one or two required target devices here.
If you select
On
for the
SNMP
parameter and do not enter an SNMP host address, the
AutoDome 800 Series does not send them automatically, but only replies to SNMP requests. If
you enter one or two SNMP host addresses, SNMP traps are sent automatically. Select
Off
to
deactivate the SNMP function.
1. SNMP host address / 2. SNMP host address
If you wish to send SNMP traps automatically, enter the IP addresses of one or two required
target units here.
SNMP traps
You can select which traps are to be sent.
1.
Click
Select
. A list is opened.
2.
Click the checkboxes to select the required traps. All the checked traps will be sent.
3.
Click
Set
to accept the selection.
Authentication
If a RADIUS server is employed in the network for managing access rights, authentication
must be activated here to allow communication with the unit. The RADIUS server must also
contain the corresponding data.
To configure the unit, you must connect the AutoDome 800 Series directly to a computer
using a network cable. This is because communication via the network is not enabled until the
Identity
and
Password
parameters have been set and successfully authenticated.
Identity
Enter the name that the RADIUS server is to use for identifying the AutoDome 800 Series.
Password
Enter the password that is stored in the RADIUS server.
RTSP port
If necessary, select a different port for the exchange of the RTSP data from the list. The
standard RTSP port is 554. Select
Off
to deactivate the RTSP function.
Summary of Contents for VG5 800 SERIES
Page 1: ...AutoDome 800 Series HD PTZ Camera VG5 800 Series en Installation Manual ...
Page 2: ......
Page 122: ......
