ECODRIVE DKC02.1 Drive Controller
Safety instructions for electrical drives
2-5
DOK-ECODRV-DKC02.1****-PRJ2-EN-P
DANGER
Dangerous movements!
Danger may result in equipment damage, personal injury
or death!
⇒
Personal safety must be ensured by higher-level,
monitoring at the installation or precautionary meas-
ures for the reasons listed above. These are provided
by the plant manufacturer according to the specific
conditions of the plant based on a danger and mal-
function analysis. The safety regulations in effect for
the plant are included herein.
Avoiding accidents:
⇒
Stay away from the machine’s movement area. Pos-
sible measures to be taken to prevent access by un-
authorized persons:
- protective fences
- protective railings
- protective coverings
- light barrier
⇒
Fences and coverings should be strong enough to
withstand the maximum possible momentum.
⇒
Mount the emergency stop (E-stop) switch at an easily
accessible place in the immediate vicinity. Verify that
the E-stop switch works before starting operation.
⇒
Isolate the drive power connection by means of an E-
stop circuit or use a starting lock-out to prevent unin-
tentional startup.
⇒
Make sure that the drives have been shut down be-
fore accessing or entering the danger zone.
⇒
Disable electrical power to the equipment using a
master switch and secure against reclosure during:
- maintenance and repair work
- equipment cleaning
- long downtime periods
⇒
Avoid operating high-frequency, remote control, and
radio equipment near electrical equipment and their
supply leads. If the use of such equipment cannot be
avoided, verify that the system and plant are in perfect
working order in all working situations before initial
operation. If necessary, the plant must undergo spe-
cial EMC testing.
LSA Control S.L. www.lsa-control.com [email protected] (+34) 960 62 43 01
