Bosch Rexroth CytroMotion, Operating Instructions Manual

Page: 43 / 60

43 / 60
Self-contained axis
Exchange of components
Bosch Rexroth AG RE62290-B, 05.22
−
The self-contained axis has to be checked consistently for abnormalities or
changes. This relates to leakages, changed noise development, loose screw
fittings/connections, unusual heat development, damage to cables etc.
−
In order to avoid electrostatic charging, clean any dust accumulation using
a damp cloth
−
The extended visual inspection includes checking that the mounting ele-
ments and fittings are seated tightly. This has to be done with the system
switched off, depressurized and cooled down.
10.4 Repair
WARNING
Improper repair!
−
For repair, the self-contained axis may only be disas-
sembled to the extent described in these operating
instructions.
−
Defective parts may only be replaced by new, inter-
changeable, tested components in original equipment
quality.
−
Only use original spare parts from Bosch Rexroth for
repairing the self-contained axis.
−
The repair may only be carried out by authorized,
trained and instructed specialists.
WARNING
Danger due to pressurized self-contained axis! Risk of
injury! Severe injury when working at systems that have
not been stopped! Damage to property! Even once the
self-contained axis has been disconnected from the elec-
trical power supply, the system is still pressurized and is
permanently pre-stressed!
−
Observe the specifications of the system manufac-
turer and the system end-user!
−
Do not disconnect lines, connections or components
as long as the self-contained axis is under pressure.
−
The hydraulic circuit may only be opened by specifi-
cally trained personnel.
Bosch Rexroth offers a wide range of repair services. For further information,
please consult Bosch Rexroth Service, see
⮫
Chapter 16.1 Service and support
on page 55 .
10.5 Spare parts
Please contact Bosch Rexroth Service for clarification regarding spare parts,
see
⮫
Chapter 16.1 Service and support on page 55 . In addition, observe the
safety instructions in these operating instructions when working with or on the
self-contained axis.
Table 11: Lifting gear / attachment devices
Designation Version Material number Data sheet /
standard
RING BOLT DIN580-M10-C15E M10 R900003438 DIN580
10.6 Exchange of components
To exchange defective components and in case of questions or doubt, please
contact the Bosch Rexroth service, see
⮫
Chapter 16.1 Service and support
on page 55 .