Bosch Rexroth CytroMotion, Operating Instructions Manual

Page: 46 / 60

46 / 60
Self-contained axis
Exchange of components
Bosch Rexroth AG RE62290-B, 05.22
2. Before starting work at live components: On the system side, disconnect
the self-contained axis from the supply voltages and secure it against
restarting.
11.3 Disassembly process
Proceed as follows to disassemble the self-contained axis:
1.
Check whether the self-contained axis has cooled down sufficiently so
that it can be disassembled in a risk-free manner.
2.
Disconnect the electric lines according to the self-contained axis
⮫
data
sheet (chapter “Electrical connections”).
3. Remove the self-contained axis. Use suitable lifting gear to do so. Refer to
the reverse order from
⮫
Chapter 7.5 Assembling the self-contained axis
on page 29 .
Ensure during all these steps that no dirt gets into the openings.
11.4 Storage / further use
Proceed as described in
⮫
Chapter 6.2 Storage on page 23 .
11.5 Exchange of components
Generally speaking, the self-contained axis may not be opened. The hydraulic
system has to remain closed. If components are defective and opening the
hydraulic system is necessary to replace or repair them, Bosch Rexroth Service
has to be called in.
The following components or tasks are not critical in this regard:
●
The cover may be removed and replaced again.
For further information or in cases of uncertainty, please consult Bosch Rexroth
Service.