Bosch Rexroth CytroMotion, Operating Instructions Manual

Page: 27 / 60

27 / 60
Self-contained axis
Unpacking
Bosch Rexroth AG RE62290-B, 05.22
7 Assembly
7.1 General information
CAUTION
Leaking hydraulic fluid! Slip hazard due to oily surfaces
or leaking hydraulic fluid. Damage to the self-contained
axis!
−
Immediately remove leaking hydraulic fluid.
−
Secure and mark the danger zone.
−
Use an oil binding agent in order to bind the leaking
hydraulic fluid.
−
Wear personal protective equipment such as safety
shoes and gloves.
−
Contact Bosch Rexroth for proper refilling of the self-
contained axis.
NOTICE
Incorrect connection of electric components. Risk of
short-circuit and damage!
−
Connect the electric components according to the
overview circuit diagram and the pin assignment.
NOTICE
Missing seals and caps! Liquids and foreign particles
may penetrate and damage the product.
−
Ensure before the assembly that all seals and caps of
the connections are tight.
NOTICE
Insufficient assembly space! Danger of component
damage! Insufficient accessibility may make the instal-
lation or the exchange of components more difficult
or impossible. Components, e.g. safety-related piping,
cannot be properly mounted or might be damaged.
−
Make sure that the assembly space is sufficient. The
dimensions can be found in the
⮫
data sheet of the
self-contained axis.
−
At no point (e.g. transport assembly etc.) may the
self-contained axis be exposed to impermissible
mechanical loads.
NOTICE
Condensed water in electrical components! Risk of
short-circuit!
−
Let the electrical components acclimatize themselves
for several hours as otherwise, condensed water may
form.
NOTICE
Major potential differences! Danger of destruction of
electrical components by connecting or disconnecting
connectors under voltage.
−
De-energize the relevant system part before assem-
bling electrical components or when connecting and
disconnecting connectors.
7.2 Unpacking
CAUTION
Parts falling out! Risk of injury! If the packaging is
opened improperly, parts may fall out and cause injuries
or damage of the parts.
−
Put the packaging on level, bearing ground.
−
Only open the packaging from the top.