Bosch Rexroth CytroMotion, Operating Instructions Manual

Page: 24 / 60

24 / 60
Self-contained axis
Storage
Bosch Rexroth AG RE62290-B, 05.22
Storage conditions Packaging Protective agent Max. storage time in months
Storage in dry
rooms at constant
temperature
For carriage over-
seas
Mineral oil 12 24
Not for carriage
overseas
Mineral oil 9 24
Outdoor storage For carriage over-
seas
Mineral oil 6 12
Not for carriage
overseas
Mineral oil - 12
Outdoor storage: Protect against damage, exposure to sunlight and water
ingress
Requirement
●
Do not store the self-contained axis outdoors but in a well-ventilated room.
●
Ensure for 100% UV protection.
●
Pay attention to the storage temperature, see the
⮫
data sheet of the self-
contained axis.
●
Protect the self-contained axis against humidity, particularly ground
humidity. Store the self-contained axis on a shelf or on a pallet.
●
Ensure that no ozone formation takes place near the storage location.
●
Self-contained axes filled with oil may not be exposed to direct solar radia-
tion or other heat sources as the increase in the ambient temperature raises
the hydraulic pressure in the cylinder.
●
Store the self-contained axis in packaging in order to protect it from dust
and dirt.
●
Store the self-contained axis so that it is safe from impacts and slipping.
●
After opening the transport packaging, it has to be closed properly again for
storage. Use the original packaging for storage.
Procedure after expiration of maximum storage time
●
Check the self-contained axis for damage and corrosion prior to installation.
●
Do a test run to check the self-contained axis for correct function and leak-
tightness.
Contact Bosch Rexroth for the preservation and later commissioning of the self-
contained axis if it is to be stored for a period of time exceeding the durations
in the table “Storage times”.
After disassembly
If the self-contained axis is to be stored, it is to be preserved for the time of
storage to protect it against corrosion.
Bosch Rexroth recommends the following procedure:
1.
Clean the self-contained axis, see
⮫
Chapter 10.2 Cleaning and care
on page 41 .
2. Close all connections so that they are airtight.
3. Unprotected parts like fitting surfaces or mechanical interfaces have to be
protected with suitable corrosion protection agents.
4. Protect the fitting surfaces against humidity
5. As deformations at the seals cannot be excluded, renew the seals. In this
connection, observe
⮫
Chapter 11 Disassembly and removal on page 45 .
In case of questions in this regard, please contact the Bosch Rexroth
service.