Bosch Rexroth CytroMotion, Operating Instructions Manual

Page: 33 / 60

33 / 60
Self-contained axis
Assembling the self-contained axis
Bosch Rexroth AG RE62290-B, 05.22
Installation of signal/control and power cables
General information
CAUTION
Interference emissions! Risk of injury due to malfunc-
tions and uncontrolled motions!
−
Eliminate sources of interference in the area of the
signal and control lines!
−
Ensure assembly according to EMC.
The achievable life cycle of the cables is largely determined by the type of
installation and environmental influences at the place of use. Due to the variety
of application conditions, the listed basic recommendations for the handling
of cables can, however, only serve as an aid to ensure a long and fault-free
operation of the cables.
●
Lay cables and lines so that they cannot be damaged and no one can trip
over them.
●
Never subject cables to stress due to pulling or torsion. Mechanically fix the
cable ends in place after no more than approx. 30 cm (e.g. cable clip, cable
tie, etc.)
●
Do not inflect cables. Do not fall below the bending radii. The value of the
bending radius are to be 5-6 times the diameter of the line.
●
Do not subject cables to large temperature differences and extreme weather
influences. Always store cables in a dry place.
●
Always unroll cables completely.
●
Never use damaged cables (e.g. by pressure, clamping or crushing). In case
of damage, decommission the system and exchange the cables.
●
Check the connection cables at regular intervals for damage and exchange
them, if necessary.
●
Check the connections for the protective grounding conductor at regular
intervals for proper condition and tight seat.
●
Do not use silicone-containing sealing, adhesive, or insulating agents.
●
Ensure a maintenance-friendly installation, i.e. simple access to the connec-
tion lines. Free access to the connection side has to be guaranteed.
●
Before installation note down the information on the name plates. If name
plates are not visible or readable any more after the installation, this data
will be available at any time.
Cable routing
●
Install signal and control lines with a minimum clearance of at least 200 mm
or use a grounded separating plate to separate them from the power cables.
Installation in separate cable channels is the optimum.
●
Replace cable markings and warnings on cable connections which have
become illegible or are missing.