Bosch Rexroth CytroMotion, Operating Instructions Manual

Page: 28 / 60

28 / 60
Self-contained axis
Accessories
Bosch Rexroth AG RE62290-B, 05.22
Dispose of the packaging in accordance with the currently applicable national
provisions in your country.
7.3 Installation conditions
7.3.1 Drive unit
●
The components mounted to the drive unit are not to be subjected to any
mechanical load (e.g. impact). The connectors and cable sockets are to be
protected against such loads.
●
Make sure that the drive unit and particularly the attached components are
not damaged during installation.
●
When installing the drive unit, always observe the environmental conditions
specified in the technical data, see the
⮫
data sheet of the self-contained
axis.
●
The dimensions can be found in the
⮫
data sheet of the self-contained axis.
When determining the space required, the installation position has to be
observed.
●
Please ensure during installation that in later operation, sufficient air
exchange will be provided to prevent overheating.
●
The drive unit is to be installed on bearing ground.
7.3.2 Cable set
Information about the installation conditions of the motor power and motor
encoder cable can be found in
⮫
Chapter Installation of signal/control and
power cables on page 33 .
The length of the cable set between the motor, resolver and motor temperature
may not exceed 50 m.
7.3.3 Installation position
The self-contained axis may be installed in any position.
7.4 Accessories
The following accessories are recommended. They are not included in the
scope of delivery and can be ordered separately from Bosch Rexroth:
Table 5: Cable set for motor
Designation Version Material number Data sheet /
standard
ASSEMBLY CBL-1X/MOT-10W4X02,5 4-pole, angled, 10.0 m R901559242 For dimensions,
see
⮫
data sheet
Table 6: Cable set for resolver and motor temperature
Designation Version Material number Data sheet /
standard
ASSEMBLY CBL-1X/CRT-10W8XSPEZ 8-pole, angled, 10.0 m R901559243 For dimensions,
see
⮫
data sheet
Table 7: Mating connectors for 2/2 directional seat valves
Designation Version Material number Data sheet /
standard
Mating connector; for
valves with device con-
nectors, 2-pole + PE,
design A
Without circuitry, M16 x 1.5,
12 … 240 V, "b"
R901017011 08006
With indicator light, M16 x 1.5,
12 … 240 V
R901017022