EN
| 64
Bosch Security Systems | 2006-05 | V2.0
Dinion IP
| Installation Manual
software). You can enter up to ten IP addresses which will be selected in order by
the unit in case of an alarm until a connection is established.
Connect on alarm
Select On so that the camera automatically establishes a connection to a pre-
defined IP address in the event of an alarm.
Note
Stream 2 is always transmitted for alarm connections. This should be taken
into account when assigning the profile.
Number of destination IP address
Here you assign the numbering for the IP addresses to be contacted in the event
of an alarm. The unit contacts the remote locations one after the other in the
numbered sequence until a connection has been established.
Destination IP address
For each number, enter the corresponding IP address for the desired remote
location.
Destination password
If the remote location is password protected, enter the password here.
Auto-connect
Select On if an active connection should be re-established automatically to one of
the previously specified IP addresses after each restart, connection breakdown or
network failure.
Note
Stream 2 is always transmitted for automatic connections. This should be
taken into account when assigning the profile.
