EN
| 17
Bosch Security Systems | 2006-05 | V2.0
Dinion IP
| Installation Manual
Note
The multicolored LED under the Ethernet connection indicates Power
(red), IP connection (green) and IP traffic (green flashing). It can be
disabled in the
Settings/Camera Settings/Installer options
menu.
Video service monitor
Alarm connector
Lens mounting
The camera accepts CS-mount lenses with a lens protrusion of up to 5mm.
C-mount lenses can be mounted using the lens adapter ring. DC-iris lenses are
recommended for the best picture performance. The camera automatically
detects the type of lens used and optimizes performance accordingly. A spare
male lens connector is provided.
VIDEO
DC 12V
AC 24V
ALARM
ETH
• connect a service monitor to the composite
video BNC connector to aid installation.
• a monitor connected close to the camera via
this connection can also be used in parallel with
remote PC viewing.
Alarm
Pin 1
Pin 4
Pin
Alarm socket
1
Ground
2
Alarm in
3
Relay out contact 1
4
Relay out contact 2
• Max. wire diameter AWG 22-28
for both stranded and solid.
• Default relay position n.o. (normally
open), no alarm.
• Alarm output relay switching
capability: Max voltage 30VAC or
+40VDC. Max 0.5 A continuous,
10VA.
• Alarm in: TTL logic, +5V nominal,
+40VDC max, DC coupled with
22kOhm pull-up to +3.3V.
• Alarm in: configurable as active
low or active high.
• Max. 42V allowed between camera
ground and each of the relay pins.
