EN
| 85
Bosch Security Systems | 2006-05 | V2.0
Dinion IP
| Installation Manual
Maintenance
9
Testing the network connection
The
ping
command can be used to check the connection between two IP
addresses. This allows you to test whether a device is active in the network.
– Open the DOS command prompt.
– Type
ping
followed by the IP address of the device.
If the device is found, the response appears as "
Reply from ...
", followed
by the number of bytes sent and the transmission time in milliseconds.
Otherwise, the device cannot be accessed via the network. This might be
because:
• The device is not properly connected to the network. Check the cable
connections in this case.
• The device is not correctly integrated into the network. Check the IP address,
subnet mask and gateway address.
Repairs
Caution
Never open the casing of the camera. The unit does not contain any user
serviceable parts.
Ensure that all maintenance or repair work is performed only by qualified
personnel (electrical engineering or network technology specialists). In case of
doubt, contact your dealer's technical service center.
Transfer and disposal
The camera should only be passed on together with this installation guide. The
unit contains environmentally hazardous materials that must be disposed of
according to law. Defective or superfluous devices and parts should be disposed
of professionally or taken to your local collection point for hazardous materials.
