BorMann 034469, Manual

Page: 9 / 31

EN
WWW.BORMANNTOOLS.COM
9
5. Internal battery grounding (Applicable types)
Remove the appearance cover plate. Use the nut of M6 to connect the battery grounding wire with cylin -
der head cover to make the ground connection of internal battery.
6. Electrical devices
Disconnect all electrical devices from the generating set and switch off the AC circuit breaker before start
the engine.
The generating set may be hard to start with electrical devices connected.
The power of connected electrical devices cannot limit the generating set Max power, specific power see
parameter sheet for reference.
7. Generating set grounding
The generating set must be property connected to an appropriate ground. It helps prevent electrical shock if a ground fault condition exists in the generating
set or in connected electrical devices, especially when the unit is equipped with a wheel kit.
Proper grounding also helps dissipate static electricity, which often builds up in ungrounded devices.
DANGER: Electrical Shock
Failure to properly ground the generating set can result in electric shock.
A ground terminal on the frame of the generator has been provided on the generator end.
For remote grounding, connect a length of heavy gauge (4mm²) copper wire between the generator ground terminal and a copper rod driven into the
ground.
Local electrical codes may also require proper grounding of the unit. We strongly recommend that you consult with a qualified electrician for grounding
requirements in your area.
B. Starting the generating set
1. Perform operating checklist and remove all loads.
2. Turn the ventilation knob to "ON'' position when engine is running to make sure the fuel flowing.
3. Turn the two-in-one switch to the "RUN" position.
4. Turn the energy saving switch to the "ON" position.
Note: Please set the energy-saving switch to "OFF" position when it needs large starting current.
5. (Suitable for hand recoil starting)
Pull out the choke lever to close the choke valve.
CAUTION: Choke position for starting may vary depending upon temperature and other factors. If re-start -
ing a warm engine, there's no need to pull out the choke lever.