BorMann 034469, Manual

Page: 5 / 31

EN
WWW.BORMANNTOOLS.COM
5
KICKBACK
Rapid retraction of the starter cord will pull hand and arm towards the engine faster than you can let go.
Unintentional start-up can result In entanglement, traumatic amputation or laceration. Broken bones, fractures, bruises or sprains.
ELECTRICAL SHOCK
This generator produces powerful voltage and the electricity CAN KILL YOU.
This generator must be properly connected to an appropriate ground to help prevent electric shock. Failure to properly ground generator can result in
electrocution, especially if the generator is equipped with a wheel kit. Consult an electrician for local grounding requirements.
Installation should be preformed by a certified electrician. Improper installation can result in electrical shock and death.
To reduce the risk of electrical shock, DO NOT use electrical cords that are worn, frayed, bare or otherwise damaged.
DO NOT touch bare wires or receptacles.
DO NOT operate generator in wet weather. Keep the generator dry.
DO NOT handle generator or electrical cords while standing in water, while barefoot, or while hands or feet are wet.
DO NOT allow unqualified persons or children to operate or service the generator.
DO NOT hook up any generator to a building electrical system without the proper use and installation of a transfer switch installed by a qualified electrician. When
using generator for backup power, notify utility company. Use approved transfer generator to isolate generator from electric utility. Failure to isolate generator
from power utility can result in death or injury to electric utility workers due to back-feed of electrical energy.
Running indicator (green)
The running indicator lights up when generating set starts and has normal output.
Overload indicator (red)
When the overload indicator is on, it indicates that the generating set is overload and
It may cause overheat of frequency converter, or increase of AC voltage. And then the AC protector
works. It will stop the output of generating set to protect the electric equipment and the generating
set itself. At this time, the running indicator (green) is off and the overload indicator (red) is on, but the
engine is still in running state.
When the generating set has no output and the overload indicator is on, please take the following steps:
1. Lower the total power of the connected electric devices to the rated output range of generating set.
2. Check the air intake for impurities and check the control parts for abnormal situation. Handle immedi -
ately if necessary.
3. Press the reset button.
Oil alarm lamp (yellow)
When the oil level drops below the lower limit, the oil protection system will stop the engine automati -
cally and oil alarming lamp will blink by pulling the recoil starter. The engine will not run until the oil has
been filled to the proper level.
Note: If engine flames out or fails to start, tum the two-in-one switch to "RUN" position and then pull
the recoil starter. If the oil alarming lamp lights up, it shows lack of oil. Please add appropriate oil and
restart the engine.
Features and controls
Choke lever
Note: when cold start, please close (pull) the choke lever.
When warm start, please open (push) the choke lever.