BorMann 034469, Manual

Page: 12 / 31

EN
WWW.BORMANNTOOLS.COM
12
D. Stopping the generating set
1. Remove the connectors of all electric equipment from the generating set panel.
WARNING: NEVER stop the engine with electrical devices connected and running.
2. (Suitable for Wireless remote control)
Press the STOP key repeatedly for 2-3 seconds to stop the generator from running.
NOTE: Replace battery when the control distance is inadequate, and/or when the indicator light on
remote control is not functioning. See maintenance section for more info.
Note: If the generator will not be in services for over 2 weeks, please tum the knob to "OFF" position,
or the battery will be out of power and the generator can not be started.
3. Turn the energy saving switch to the "ON" position.
4. Allow the generating set run at no load for a few minutes to stabilize Internal temperatures of the
engine and generating set.
5. Turn the two-in-one switch to ''OFF" position.
E. Parallel operation (If applicable)
Make sure that the generating set is in a good running state before connecting it to other generating sets. The total power of electric devices should not
exceed rated power of generating set.
When electric motor starts the overload indicator (red) will light up and normally it will stop within 4 seconds. If it cannot stop, please consult your local
dealer.
During parallel operation, energy-saving switches of generating sets should be in the same position.
1. Connect one generating set to other generating set(s) in parallel. Use the parallel kit to make the parallel connection (the parallel kit needs to be purchased
separately).
2. Start the engine in proper order and make sure that the running indicator (green) is normal.
3. Connect the plug of electric devices to the AC receptacle of parallel kit.
4. Run the electric devices.
CAUTION: When overload too much, overload Indicator (red) blinks continuously, and the generating set may be damaged. When overload a little, overload
indicator (red) lights up continuously, It may shorten the service life of generating set.
When continuously operating the generating set, power cannot exceed the rated power of generating set.
The total power of electric devices cannot exceed the rated power of generating set.
The manufacturers of electric devices or tools always list the rated power of similar models or serial number.
Maintenance
It is owner's/operator's responsibility to complete all scheduled maintenance in a timely manner. Correct any issue before operating the pump.
Always follow the inspection and maintenance recommendations and schedule in this manual.
DANGER: Accidental starts can cause severe injury or death. Remove and ground spark plug wire before performing any service.
Maintenance schedule
Service the pump in a clean, dry and flat area. Follow the service intervals indicated in the chart below. Service your pump more frequently when operating
in adverse conditions.
Contact your local service dealer for your pump maintenance needs.
WARNING: Improper maintenance or failure to correct a problem before operation can cause a malfunction and result in property damage, serious injury or
DEATH.
Improper maintenance will void your warranty.
CAUTION: The filter element may contains PAHs, PAHs are harmful for your health. Please wear gloves for protection during air filter maintenance.