![background image](http://html1.mh-extra.com/html/boretti/ml9015ifsan/ml9015ifsan_user-manual-installation-advice_2788322051.webp)
51
Inside of oven
The oven should always be cleaned after use when it has cooled down.
The cavity should be cleaned using a mild detergent solution and warm
water. Suitable proprietary chemical cleaners may be used after first
consulting with the manufacturers recommendations and testing a small
sample of the oven cavity. Abrasive cleaning agents or scouring pads/
cloths should not be used on the cavity surface.
Let the oven cool down and pay special attention no to touch the hot
heating elements inside the oven cavity.
Fire risk!
Do not store flammable material in the oven
Advice for use and maintenance of catalytic panels
The catalytic panels are covered with special microporous enamel which
absorbs and does away with oil and fat splashes during normal baking
over 200°C.
If, after cooking very fatty foods, the panels remain dirty, operate the oven
“idling” on max temperature for about 30 minutes. These panels do not
require to be cleaned, however it is advised to periodically remove them
from the oven (at least the side panels) and to wash them with tepid
soapy water and then wipe off with a soft cloth.
Do not clean or wash them with abrasive products or with products
containing acids or alkalis
The side panels are reversible and when the catalytic microporous enamel
degrades, they can be turned to the other side.
Electronic programmer display cleaning
Clean the programmer display using a soft cloth, warm water and neutral
soap, or a soft cloth with a liquid detergent (non-abrasive). When cleaning,
be careful to move the cloth in one direction only. Then wipe the display
with a damp cloth and dry it with a soft cloth.
Note
The manufacturers of this appliance will accept no responsibility for
damage caused by chemical or abrasive cleaning.
EN
Bor
etti Milano / User guide - Installation advice