27
Caution!
The front cooking zone will operate at the selected setting.
If no pan is detected on front cooking zone the front cooking zone display
shows the symbol
and the rear cooking zone display will alternate
between selected setting and
.
Caution!
The rear cooking zone will operate at the selected setting.
If after 10 minutes no pan is detected:
*
the bridging function will switch off.
*
the cooking zone without a detectable pan will continue to show
*
the remaining cooking zone will continue cooking at the selected heat setting.
“Fast heating” function
Turn the control knob anti-clockwise to the
A
setting and then release the
knob (after the “beep”); the relative
symbol lights up on the cooking
zone display. Within 10 seconds turn the knob to the desired power
level (between
1
and
9
); once a setting has been selected, and the
chosen power level will flash in alternation on the control panel display.
This function allows the cooking zone to operate at the maximum power
(100%) for a time proportional to the selected power level; after this
time the cooking zone will operate at the selected level. This function is
available on all the cooking zones. While this function is operating it is
possible, at any time, to increase the selected power level but it is not
possible to decrease the power; by turning the knob anti-clockwise to
a lower level the function will be disabled.
The function will be disabled also by turning the knob to the “
0
” (Off)
position or by selecting the “Booster” function.
Note
If removing the pan from the cooking zone before the programme has
been completed, the “Fast heating” function will be completed with
the remaining time if the pan is put back on the cooking zone within
10 minutes.
EN
Bor
etti Milano / User guide - Installation advice