61
A) Gas connection
CAT: II 2EK3B/P
The gases used for the operation of cooking appliances may be
grouped by their characteristics into two types:
*
G25.3 natural gas
*
G20 natural gas
*
G30 / G31 Butane/Propane
The fitting (fig. 8.2) is made up of:
A - Gas train terminal fitting (rh or lh)
B - Gasket
C - Conical connector
Use rigid or flexible connection pipes which comply with applicable
regulations. If compression fittings are used, tighten firmly using two
spanners (fig. 8.4). In particular, make sure that:
*
The flexible hose does not come into contact with any parts of the
cooker with surface temperatures in excess of 70˚C;
*
The flexible hose does not exceed 75 cm in length and does not
come into contact with sharp edges or corners;
*
The hose is not under tension or twisted and is not kinked or
too tightly bent;
*
The connection with rigid metal pipes should not cause stresses
to the gas ramp.
*
We advise replacing the gasket on the slightest sign of
deformation or imperfection.
*
The hose can easily be inspected along its entire length to check its
condition; hoses should replaced after a maximum of three years.
*
The cylinder cock or the supply cock immediately ahead of the
appliance is closed whenever the cooker is not in use.
EN
Bor
etti Milano / User guide - Installation advice
Summary of Contents for MFBG 901 AN BE
