18
Lighting gas burners fitted with
safety valve device (Dual burner)
In order to light the burner, you must:
1. Push and turn the knob in
clockwise or anticlockwise
direction up to the
position
(maximum rate of inner crown)
or
position (maximum rate
of inner + outer crown), push in
and hold the knob until the flame
has been lit (fig. 3.4a or 3.4b).
The sparks produced by the
lighter situated inside the relative
burner will light the flame. In the
event that the local gas supply
conditions makes it difficult to
light the burner in
or
position, try again with the knob in
or position. If there is no main
electrical supply, bring a lighted
match close to the burner.
2. Wait for about ten seconds
after the gas burner has been
lit before letting go the knob
(safety device activation delay).
3. Adjust the gas valve to the
desired position.
If the burner flame should go out for
some reason, the safety valve will
automatically stop the gas flow.
To relight the burner, return the knob to the closed “ ” position,
wait
for at least 1 minute
and then repeat the lighting procedure.
EN
Bor
etti Milano / User guide - Installation advice
Summary of Contents for MFBG 901 AN BE
