BOMBARDIER BD-100-1A10, Operating Manual

Page: 335 / 544

FLIGHT INSTRUMENTS
Dec 05/2006 Flight Crew Operating Manual Volume 2
REV 7 CSP 100-6
11-01-29
DISPLAY CONTROL PANEL (DCP) (Cont)
RADIO
Pressing the RADIO button selects and deselects, on the MFD, the tuning control sub-menu of the radio associated with
the current position of the tuning control. Pressing the RADIO button when another menu is displayed closes the menu and
returns the tune box to its home position.
BRGSRC (BEARING SOURCE)
The BRG SRC button displays a menu of Bearing pointer sources on the PFD with the current Bearing pointer source high-
lighted. The Menu knob and Data knob and Push Select are used to select and deselect the Bearing pointers.
MENU/DATA/PUSH SELECT
The MENU knob is a rotary control used to move a cyan selection box, to allow activation of various display items on the
PFD and MFD. The DATA knob is a rotary control used to change the value in the selection box.
The PUSH SELECT button located in the center of the MENU/DATA knob makes the value entered with DATA knob, the
active display value or change the state of the item in the selection box.
REFS (REFERENCE)
The selected V-speed references are displayed on the airspeed display. V
1
, V
R
, V
2
, V
T
, V
GA
, and V
REF
are initialized to
default values but deselected, which the pilot may change as required.
The REFS push button located on the DCP is used to select the desired reference menu. Repetitive pushes of the REFS
button toggle through the three pages of the REFS menu.
RADAR
The RADAR button selects and deselects the radar control menu on the PFD. The radar control menu provides mode,
ground clutter suppression, gain, sector scan, and target.
TILT-RANGE/PUSH AUTO TILT
The RANGE knob is a rotary knob with a function to control the decrease or increase of the PFD and MFD Nav display
range until the minimum or maximum range is reached.
The TILT knob is a rotary control to select the radar antenna tilt range (-15 to +15 degrees).
The PUSH AUTO TILT button located in the center of the RANGE/TILT knob selects and deselects automatic tilt control.
DISPLAY CONTROL PANEL WARNING FLAG
A display control panel (DCP) failure results in the display of an amber boxed DCP flag. This flag will appear on the PFD
and MFD displays.