FUEL
Volume 2
Flight Crew Operating Manual
Sep 13/2004
12-01-08
CSP 100-6
REV 1
REFUELING/DEFUELING (Cont)
GROUNDING RECEPTACLES
Receptacles for grounding the aircraft to the refueling equipment are provided as follows:
- Adjacent to each gravity filler port
- Adjacent to the pressure refueling coupling
- Nose gear stud
SYSTEM TEST
The automatic pressure refueling, manual pressure refueling and automatic defueling procedures can be used after satisfac-
tory tests on the refuel/defuel system. The tests are to verify that all panel lamps operate correctly, the SOVs
operate correctly in manual and automatic modes.
Test the panel lamps with the following procedures:
- Select power switch ON
- Push Lamp Test button and verify all panel indication lamps illuminate
- Connect fuel nozzle to the refuel/defuel adapter to supply fuel pressure
- Select TEST position on the fuel selector switch
- Verify H. LEVEL DETECTOR, SOV CL and OP lamps illuminate
- Select OFF position on the fuel selector switch
- Verify that only the SOV OP lamps illuminate
Test the SOV operation with the following procedures:
- Select FUEL AUTO position with the fuel selector switch and the two SOV toggle switches OFF
- Verify SOV indication lamps are off
- Select FUEL AUTO position with the fuel selector switch and the two SOV toggle switches ON
- Verify SOV indication lamps illuminate OP
- Select TEST position with the fuel selector switch and the two SOV toggle switches ON
- Verify SOV lamps illuminate CL
HIGH-LEVEL SENSORS
The high-level sensors provide the fuel computer with a tank full signal, and provides for a 3% expansion space. When the
high-level sensor signals the computer a full condition during refueling operations, the computer closes the respective re-
fuel shutoff valve.
REFUEL/DEFUEL SINGLE-POINT ADAPTER
The refuel/defuel single-point adapter lets the operator connect the refueling nozzle to the aircraft to refuel or defuel. The
adapter is installed in the right fuselage fairing just forward of the right wing.
GRAVITY REFUELING
Gravity refueling is accomplished only in exceptional circumstances. The refueling process is done through the filler ports
located on the upper wing surfaces. Due to the shallow depth of the wing at the location of the filler cap, a protective plate
is provided in the tank in order to avoid damage to the bottom skin by the refueling nozzle.
The gravity filler port and cap for each wing tank is located approximately mid-wing.
WARNING:
Gravity filler caps for the wing tanks are located below the maximum pressure refueling level. Never re-
move the gravity filler caps if the wing tanks are full or fuel quantity is unknown.
Summary of Contents for BD-100-1A10
