Troubleshooting
If the computer is
not picking up your hand pulse signal
(or you are getting
inaccurate readings), please adjust the following:
1.
Slightly moisten/dampen the palms with water so the sensors can detect a
pulse signal.
2.
Do not grip the sensors too tightly. Only moderate pressure need be applied.
Gripping the sensors too tightly restricts and seizes detection of your pulse.
3.
Remove any rings or jewelry to prevent interference.
4.
Check to ensure all pulse sensor wires are properly connected and are
not damaged.
You may need to refer to installation/assembly directions for the pulse sensor
wires in this manual.
If the computer is
not displaying the CALORIES/DISTANCE/TIME/(ETC.) functions
(or you are getting inaccurate readings), please adjust the following:
1.
Check to ensure all computer sensor wires are properly connected and are
not damaged.
You may need to refer to installation/assembly directions for the sensor wires
in this manual.
If the computer
display is blank & not displaying any data
(or does not appear to
power on), please adjust the following:
1.
Check to ensure all sensor wires are all properly connected and are
not damaged.
2.
Check to ensure the AC Adapter* or Batteries* are properly plugged in or
fully charged.
Troubleshoot Area
HAND PULSE SIGNAL
CALORIES/DISTANCE/
TIME/(ETC.)
COMPUTER Display
(AFTER COMPLETE ASSEMBLY)
Solution
*
Please check your product manual to determine if your model uses either
1. an AC Adapter, or 2. Batteries to power your unit.
For your safety, please do not discard this Troubleshooting sheet or the Owner’s Manual, and keep them in a place where you can easily
access/refer to them at any time. If you are still having any troubleshooting issues, please contact our Customer Support for further assistance.
Page 21
BRT 3858
