724-746-5500 | blackbox.com
Page 30
Chapter 3: Installation
Figure 3-37. Top Section of Shell above Cabled DC Power Connector in Bottom Section of Shell.
g. Make sure the DC power connector sits properly in the bottom section. Then snap the top and bottom sections together, as
shown in Figure 3-38.
NOTE: Make sure the cables do not get caught between edges of the shell. The cables should fit through the cable hole without
catching on an edge.
Figure 3-38. Closed Shell Assembly.
h. If you need to take the case apart, grasp each flange of the top section and gently pull them away from the latches on the
bottom section. Then pull the top section off the bottom section. Repeat step 8a through step 8g to reassemble the connector
case.
NOTE: Figure 3-39 shows the standard orientation of the WRT4000 Series Router’s DC power input port.
Figure 3-39. WRT4000 Series Router DC Power Input Port.
Flanges on the plug (Figure 3-40) allow it to fit into the DC power input port on the backplate of the WRT4000 Series Router
chassis in only one way. You may need to turn the plug over to fit it into the port.
