Black Box TS560A, User Manual

Page: 46 / 67

43
Target Setup is the sub-menu title screen used when
selecting and configuring IP addresses for the four
available target IP address storage locations. For the
PING test mode, only one target can be active at a time.
Pressing the SEL button moves the LAN Solution
Network Tester into the target selection screen. The
up/down arrow buttons scroll through the five available
options. You can select one of the four stored target
addresses or disable the target PING. To exit this sub-
menu, press SEL (this takes the tester back to the sub-
menu title screen), or press CABLE or NTWRK (to
enter a test mode). Exiting this menu will leave the
displayed target as the active one.
When one of the four targets is displayed on the screen,
press the SEL button to drop into the edit IP address
screen for that target. Edit the IP address by moving the
cursor left and right (use the left/right arrow buttons)
and then change the digit above the cursor (use the
up/down arrow buttons).
NOTE
The IP address is displayed in the typical decimal dot
format.
CHAPTER 5: Setup Mode