54
Figure 58 – Analog Input Connection
Press Configure softkey in the Setting and Measurement screen. Configure as follows
:
Config 1(default) → Config 2 → Limits
Press Config 2 softkey to enter the Configuration 2 setting page. Use the arrow key (
▲
▼
)
to move the cursor to the External Ref., then press the ENTER key to change value. Select
the Amp softkey and press ENTER to save the setting.
Figure 60 - Configuration 2 Amp mode
Press ESC to go back to the Setting and Measurement screen. Set the arbitrary waveform
generator, to output 6Vrms / 60Hz sine wave, then press On/Off key to start the output. If
the AC output voltage range is 150V, the output voltage will be 150Vrms.
www.
GlobalTestSupply
.com
Find Quality Products Online at:
