BT-750 Operator Manual 17
P/N : OPM(BT-750)EN Bistos Co.,Ltd. Rev.02(2013.04.12)
Chapter 4
BT-750 Operation
Prior to the Use of BT-750
Make sure of followings prior to check the state of patient.
Check if there is any factor to occur mechanical problem
Review the cosmetic state of probe
Check if there is any error in fiber-optic probe and AC power cable.
Connect the probe to the probe port.
Turn on the monitor and identify that the state of fiber-optic probe is normal and the
cable is connected.
Identify that fiber-optic probe has any problem on connection.
4.1 Operation
1) Turn on the power.
2) Adjust the setting with exterior button when change of the value required.
3) Figure and waveform are created on LCD screen once ECG probe connected to the
patient.
4) If you apply the SpO2 probe to the patient, data of the patient is displayed on LCD.
5) Apply NIBP cuff to patient. Avoid the arm with SpO2 probe.
6) Apply IBP Kit to patient. Avoid the arm with NIBP cuff.
7) Connect the temperature sensor to the proper position of patient at the type of the sensor.
8) Apply CO2 kit. (optional function)
※
Operation Notice
-
Only licensed person must use BT-750.
-
Read carefully followings prior to use the equipment.
-
Check the state of battery charging.
-
Make sure that power and probe are connected correctly to the monitor.
-
Avoid sudden impact when the machine is transported or each unit is connected.
-
Read carefully followings prior to use the equipment.
-
Identify that any error does not occur in entire equipment and patient.
-
Care for the patient safely and preferentially if any error is found on equipment and take
possible action such as stopping the device operation.
-
Do not give any impact to the equipment.
-
Keep the probe not to be taken off from the port for exact measurement.
4.2
Turn off the monitor
Turn off the sub-power and verify if the LCD screen turns off.
