BT-750 Operator Manual 13
P/N : OPM(BT-750)EN Bistos Co.,Ltd. Rev.02(2013.04.12)
Precautions for Settings
Pay attention when setting BT-750 for the following points
● Use BT-750 under conditions of 10
℃∼
40
℃
of circumstantial
temperature and within 80
％
humidity.
● Check the connection status of the power cord.
● Do not connect multiple cords to the power supply.
Place the main body on a flat area.
If noise occurs, ground the equipment further.
All information is stored in the internal memory, even in the case of power on and off.
Do no use any electric cords generating connecting noise.
Take care since the product can be broken by mechanical shock.
Get rid of dust or inflammable material near the product when setting it up.
3.5.1. How to Use when power is on.
1) Insert AC Adaptor to AC-IN Connector at the rear of BT-750
2) Turn on the On/Off switch at the rear of BT-750
( If the power is in Stand-by , battery starts to charge. )
3) If AC lamp of the front side (Green light) is on and you press the power switch
[
AC Adaptor Ports
]
[
the front side of the product
]
Note
Though AC power cord is connected, charging lamp continuously
lights on and after completing charging, the lamp turns off.
※
AC Power
If AC power is connected to the monitor and turn on the AC power switch, Green LED is on to
indicate Power-on. It is automatically converted to a recharging mode. (Input 100~240V, 50/60Hz)
Caution
Noise may occur in waveform, while using AC power. In this case,
ground the product.
It may occur the fatal damage to the product ,while connecting AC
power with wet hand.
3.5.2 How to Use Battery
If you continuously press the sub power switch for
about 1 second, the power is on.
Lamp is on during battery charging. (Orange light)
If you turn on the main power switch, the lamp
lights up while AC adaptor is connected.
