Rev. 2.2
26
Power
The BM1 monitor uses a DC adapter (100-240 VAC / 15VDC 2.0A). In the event of a power outage
or cable shortage, the monitor automatically switches to battery power to continue patient
monitoring without data loss.
The built-in battery is intended for back-up use only during power-off.
DC Adaptor information
Manufacture:
BRIDGEPOWER CORP.
Model name:
JMW128
Input Power:
100V~240V 1.2A
Output Power:
15V, 2.0A
DC Power LED is lighted on when the DC Power is plugged into the inlet at the back of the product.
A press of power key makes the machine ready for use.
CAUTION
This equipment must be connected to a protective earth grounded power supply.
Using non-standard products other than the adapters supplied by us may cause signal
distortion or noise. Be sure to use a genuine adapter that is supplied by our company and is
insulated.
Summary of Contents for BM1
