Rev. 2.2
81
⑤
SpO2 Value display
⑥
SpO2 Value unit
⑦
SpO2 Pulse rate display
The current SPO2 value and the derived pulse rate (RATE) are displayed.
The block sets indicate the strength of the signal (ten block bars indicate the strongest signal).
The SPO2 measurements are averaged over a 6-second period of time.
The monitor display is updated every second.
NOTE
SpO2 wave size is changed automatically.
SpO2 Signal and Data Validity
It is extremely important to determine that the probe is attached to the patient correctly and the
data is verifiable. To make this determination, three indications from the monitor are of assistance—
signal strength bar, quality of the SpO2 waveform, and the stability of the SpO2 values. It is critical
to observe all three indications simultaneously when ascertaining signal and data validity.
Signal Strength Bar
The signal strength bar is displayed within the SpO2 values window. This bar consists of 10 blocks
set depending on the strength of the signal. Proper environmental conditions and probe attachment
will help to ensure a strong signal.
Quality of SpO2 Waveform
Under normal conditions, the SpO2 waveform corresponds to (but is not proportional to) the arterial
Summary of Contents for BM1
