Rev. 2.2
101
EtCO2 Connecting and Sampling Method
Connecting the CAPNOSTAT® 5 CO2 Sensor to the Host System
1.
Insert the CAPNOSTAT 5 CO2 Sensor connector into the receptacle of the host monitor as
shown in Figure 1.
2.
Make sure the arrows on the connector are at the top of the connector and line up the
two keys of the connector with the receptacle and insert.
3.
To remove the connector, grasp the body portion of the connector back and remove. Do
not remove by pulling cable.
4.
Shown below is the CAPNOSTAT 5 CO2 Sensor connection to a Respironics Novametrix
CO2 adapter.
5.
Shown below is the CAPNOSTAT 5 CO2 Sensor with a patient circuit.
Summary of Contents for BM1
