BIG ASS FANS powerfoil x2.0, Installation Manual

Page: 4 / 76

8’–24’ POWERFOIL
®
X2.0 WASHDOWN & POWERFOIL
®
X2.0PLUS WASHDOWN
WWW.BIGASSFANS.COM ©2012 DELTA T CORP. ALL RIGHTS RESERVED
ii
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
WARNING: Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to
prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a
prominent warning device, such as a tag, to the service panel.
WARNING: Big Ass Fans must be installed with Big Ass Fan-supplied controllers. Other parts cannot be substituted.
CAUTION: The installation of a Big Ass Fan must be in accordance with the requirements specified in this installation manual
and with any additional requirements set forth by the National Electric Code (NEC), ANSI/NFPA 70-2011, and all local codes. Code
compliance is ultimately YOUR responsibility! Failure to comply with these codes could result in personal injury or property
damage.
WARNING: The fan controllers contain high voltage capacitors which take time to discharge after removal of mains supply. Before
servicing the fan controller, ensure isolation of mains supply from line inputs at the controller. Wait three minutes for capacitors
to discharge to safe voltage levels. Failure to do so may result in personal injury or death. Note: Darkened display LEDs are not an
indication of safe voltage levels.
CAUTION: Exercise caution and common sense when powering the fan. Do not connect the fan to a damaged or hazardous power
source. Do not attempt to resolve electrical malfunctions or failures on your own. Contact Big Ass Fans if you have any questions
regarding the electrical installation of this fan.
CAUTION: When service or replacement of a component in the fan requires the removal or disconnection of a safety device, the
safety device is to be reinstalled or remounted as previously installed.
WARNING: Risk of fire, electric shock, or injury to persons during cleaning and user-maintenance! Disconnect the fan from the
power supply before servicing.
CAUTION: Do not bend the airfoils when installing, adjusting, or cleaning the fan. Do not insert foreign objects between rotating
fan airfoils.
WARNING: Stay alert, watch what you are doing, and use common sense when installing fans. Do not install fans if tired or under
the influence of drugs, alcohol, or medication. A moment of inattention while installing fans may result in serious personal injury.
CAUTION: Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and
standards.
CAUTION: Use this fan only in the manner intended by the manufacturer. If you have questions, contact the manufacturer.
CAUTION: The installation of this fan requires the use of some power tools. Follow the safety procedures found in the owner’s
manual for each of these tools and do not use them for purposes other than those intended by the manufacturer.
CAUTION: The Big Ass Fans product warranty will not cover equipment damage or failure that is caused by improper installation.
CAUTION: Do not operate fan with a damaged cord or plug. Return fan to an authorized service facility for examination or repair.
WARNING: This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of
the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the
appliance.
Leave this installation guide with the owner of the fan after installation.
Suitable for use in wet locations and outdoor use when installed in a GFCI protected branch circuit.
ATTENTION: If installing the fan in the United States, the fan must be installed per the following National Fire Protection
Association (NFPA) guidelines:
• The fan must be centered approximately between four adjacent sprinklers.
• The vertical distance from the fan to the sprinkler deflector must be at least 3 ft (91.4 cm).
• The fan must be interlocked to shut down immediately upon receiving a waterflow signal from the alarm system.