BIG ASS FANS powerfoil x2.0, Installation Manual, Page: 29 / 76

8’–24’ POWERFOIL
®
X2.0 WASHDOWN & POWERFOIL
®
X2.0PLUS WASHDOWN
21
WWW.BIGASSFANS.COM ©2012 DELTA T CORP. ALL RIGHTS RESERVED
8’–24’ POWERFOIL
®
X2.0 WASHDOWN & POWERFOIL
®
X2.0PLUS WASHDOWN
Installing Guy Wires
1. Attach locking carabiners to main fan unit
Attach the (4) locking carabiners to the guy wire clips on the
main fan unit as shown. Securely tighten the carabiners.
WARNING: Ensure power is disconnected from the fan before installing the guy wires.
2. Attach beam clamp
Attach the beam clamp to the mounting structure. The guy wire should
be approximately 45° from the horizontal plane. Place the beam clamp
accordingly. Refer to the illustrations on the following page. Fully tighten
the set screw to secure the clamp.
Fasten the small eyebolt and nut onto the beam clamp. The nut will be on
the outside of the beam clamp.
Loop the crimped end of the guy wire into the locking carabiner and
secure to the eyebolt as shown. Securely tighten the carabiner.
Guy Wire Hardware (BAF-Supplied):
a. 1/4” Beam Clamp
b. 1/4-20 x 1” Eyebolt
c. 1/4-20 Hex Nut
d. Locking Carabiner
e. Guy Wire
Beam Clamp
a
c
b
d
e
Guy wires may not be included in your fan order. They are intended to constrain the fan’s lateral movement and are
only included with fans that have extension tubes 4 ft (1.2 m) or greater in length. Depending on the conditions at the
installation site, guy wires may be needed for fans with shorter tubes to prevent any lateral movement. If guy wires are
needed and were not included with your fan order, contact Big Ass Fans Customer Service.