BIG ASS FANS powerfoil x2.0, Installation Manual

Page: 27 / 76

8’–24’ POWERFOIL
®
X2.0 WASHDOWN & POWERFOIL
®
X2.0PLUS WASHDOWN
19
WWW.BIGASSFANS.COM ©2012 DELTA T CORP. ALL RIGHTS RESERVED
8’–24’ POWERFOIL
®
X2.0 WASHDOWN & POWERFOIL
®
X2.0PLUS WASHDOWN
Hanging the Fan
2. Secure upper safety cable
Wrap the safety cable around the mounting structure and secure the looped ends with the shackle as shown. The cable must be drawn
tightly around the I-beam or angle iron, leaving as little slack as possible. The shackle should be on the topside of the I-beam or angle
iron if possible. Securely tighten the shackle.
Angle Iron Mount
I-Beam Mount Shackle
Direct Mount
Slots facing
downward
1. Attach extension tube (to upper yoke)
Fasten the extension tube to the upper yoke with the Extension Tube
Hardware as shown. In order to efficiently drain water, the tube must be
oriented so that slots on the bars between the extension tube flanges are
facing downward. Refer to the illustration below.
Ensure the extension tube is hanging plumb to the ground, and then
tighten the hardware so that it is snug, but not fully tightened.
Extension Tube Hardware (BAF-Supplied):
a. (2) 1/2-13 Nylock Nut
b. (4) 1/2’’ Flat Washer
c. (2) 1/2-13 x 4-1/2’’ GR 8 Bolt
b
a
c
b
The safety cable is a crucial part of the fan and must be installed correctly. If you have questions or require assistance,
call Customer Service for assistance.