BIG ASS FANS powerfoil x2.0, Installation Manual

Page: 25 / 76

8’–24’ POWERFOIL
®
X2.0 WASHDOWN & POWERFOIL
®
X2.0PLUS WASHDOWN
17
WWW.BIGASSFANS.COM ©2012 DELTA T CORP. ALL RIGHTS RESERVED
8’–24’ POWERFOIL
®
X2.0 WASHDOWN & POWERFOIL
®
X2.0PLUS WASHDOWN
5a. Attach upper yoke (to angle irons)
Secure the upper yoke directly to the angle irons with the Upper Yoke Hardware as shown. The angle irons should be aligned with the
outermost holes of the upper yoke. Consult the diagrams below for distances between the angle irons.
Tighten the bolts to 40 ft·lb (54.2 N·m) using a torque wrench and 3/4” socket. After attaching the upper yoke to the angle irons, tighten
all the bolts securing the angle irons to the roof structure to 40 ft·lb (54.2 N·m) .
Proceed to “Hanging the Fan” (p. 19).
Upper Yoke Hardware (BAF-Supplied):
a. (4) 1/2-13 x 2” GR 8 Bolt
b. (8) 1/2’’ Flat Washer
c. (4) 1/2-13 Nylock Nut
Mounting Structure: Bar Joists (cont.)
Note: Dashed lines represent angle irons in the above illustrations.
Side View
a
b
c
b
10-7/8” (27.6 cm)
Small Upper Yoke
13-3/4’’ (34.9 cm) x
9-5/8” (24.4 cm)
15-5/8” (39.7 cm)
Large Upper Yoke
18-1/2’’(46.9 cm) x
9-5/8”(24.4 cm)
If the fan will be directly mounted to the angle irons, skip this step and proceed to step 5b.
Before drilling the angle irons, confirm that you have the appropriate mount to accommodate the roof pitch of your
mounting structure.
The angle irons should be aligned with the outermost holes on the upper yoke. Do not use beam clips on angle irons!