Beta Max MAXIAL TRACK HOIST, Use And Maintenance Instruction Manual

Page: 86 / 160

Use and Maintenance Instruction Manual
MAXIAL TRACK HOIST
REV. 2.2 (2017)
PREPARATION FOR MACHINE USE
Page | 8-3
NOTE:
Carry out the verification tests with one switch at a time in order to clearly
identify any malfunctions.
8.3.2 Electrical verification of the machine
In order to test and ascertain that the electrical command and control devices work perfectly
well, proceed as described below:
— check that all the STOP pushbuttons function properly. For this purpose, carry out trial
runs with each STOP pushbutton pushed
— perform trial runs in order to verify the functionality of the Overweight System
— perform trial runs in order to verify the functionality of the Slack Rope Assembly
8.3.3
Verification of the machine’s motion
In order to test the machines motion, proceed as described below:
— visually check the machine’s wire rope and ensure that it is free from any damage.
Monitor this constantly
— ensure that the load does not exceed the maximum allowed - refer to the information
given on the label indicating the load capacity
— press the ENGAGE/START pushbutton to ensure the system is activated
— press the pushbutton to drive the machine in the desired direction and the machine will
start-up. At the extreme levels the machine will automatically stop by means of the
Overweight System or Slack Rope Assembly