Beta Max MAXIAL TRACK HOIST, Use And Maintenance Instruction Manual

Page: 107 / 160

Use and Maintenance Instruction Manual
MAXIAL TRACK HOIST
REV. 2.2 (2017)
MAINTENANCE AND REPAIR
Page | 10-16
To perform the Overweight Limit Switch Adjustment, follow the procedure below:
1. Add approximately 350 lbs of weight onto the carrier basket and lift the load up
approximately 6-8 ft
2. Install the Bottom Stop in the track above the Maxial motor pack unit for safety
3. With the weight hanging measure the gap between the shroud and the top ladder
track rung that the motor pack floats between at the top left and the top right.
4. Adjust the Tension Adjustment Bolts, located at the bottom of the motor pack,
accordingly to balance the gap on both sides (if the unit can not be balanced
inspect the placement of the motor pack to the rungs
– the motor pack should be
completely against the ladder track rung
– adjustments to the flipper locks may
need to be done)
5. Remove the Bottom Stop and add 450 lbs of weight onto the carrier basket
6. Raise the load approximately 6-8 ft
7. Ensure the overweight limit switch will strike the bottom ladder track rung in the
center

If the unit does not raise the load, increase the tension on the Tension
Adjustment Bolts evenly in half a turn increments until the unit lifts the load

If the unit picks up the load release the tension on the Tension Adjustment
Bolts evenly in a half turn incredment until it will no longer lift the load, then
tighten one half revolution on the Tension Adjustment Bolts
8. Lower the weight to the ground and increase the weight to 500 lbs in the carrier
basket

If the unit lifts the load decrease tension on the Tension Adjustment Bolts
evenly in quarter turn incredments until the unit will not pick up the load

If the unit does not pick the load all adjustments are final
9. Lower and remove the weight
10. The unit is now ready to be placed back into service.