74
Cleaning
If the machine is stored in a cold room, it
should be brought to a warm room about
1 hour before use.
Cleaning
Periodically remove thread lint and
remnants which collect under the stitch
plate.
· turn power switch to “0”
· remove presser foot and needle
· open the free-arm cover
· press the stitch plate down at the back
right corner
· lift and remove it
· clean the area with the brush
· replace the stitch plate
Cleaning the hook
· power switch to “0”
· remove the bobbin case
· clean the hook using the brush provided
or a cotton swab. The use of any sharp
instrument could damage the hook.
· insert the bobbin case
Important!
Never use oil, alcohol or
solvents of any kind on any
part of the machine!
Lubricating
· squeeze 2–3 drops of oil
into the hook race
· run the machine for a
short time without
thread to prevent oil
soiling your work
Cleaning the screen
· wipe with a damp cloth
Cleaning the machine
· wipe with a damp cloth
· if very soiled, wipe with a solution of
water and a few drops of liquid soap
Cleaning, Maintenance, Troubleshooting
Replacing the bulp
Front cover
· turn power switch to “0”
· loosen the screw
Note:
Use bulb type
12V 5W W2.1 x 9.5d
Change the bulb
· remove the left side cover
· remove the bulb
· insert the new bulb
· replace cover and tighten
screw
Warning:
Let the bulb cool down
before replacing!
Please refer to the safety instructions!
For models with new sewing-light see page 75
bed_artista_180_engl_V3 7.10.2002 16:30 Uhr Seite 74
