Bernal G 501, User Manual

Page: 17 / 62

17
GB
2.3.1 – 2.3.2 – 2.3.4 – 2.3.5 – 2.3.6 – 2.3.7
Observe the notes on routing cable provided under
2.3.4! Only use original accessories released by the ma-
nufacturer!
Connections which make it necessary to perform pro-
gramming can only be performed AFTER the first set-up
of the paths and the force (see 5).
Acceptance testing of the housing cover and the drive hood is
essential for connecting accessories: first pull out the power
plug and secure it against plugging it in again.
Unfasten the drive cap anticlockwise and remove it (Figure 35,
a).
Unfasten the fastening screw for the drive cover (Figure 35, b)
and remove the drive cover (Figure 35, c).
The covers on the 230 V/AC area of the control board (see Fi-
gure 40) should never be removed!
The terminal strips on the accessories can be plugged in (not:
antennae) and can be pulled out to make a simple connection.
The cables for accessories should be guided according to Figu-
re 36 out if the drive housing.
4. ELECTRICAL CONNECTIONS
! PROFESSIONAL EXTENSIONS !