Fitting and wiring
FC5101 and FC5102
13
Version: 2.0
3
Fitting and wiring
3.1
Installation
NOTE
Qualified installation
Fieldbus PCI cards may only be fitted by qualified personnel and the following points must be observed.
• In order to protect the card from electrostatic discharge the user must be discharged before handling
the card or the PC.
• Before opening the PC housing it must be switched off, and the mains plug must be removed.
In may be necessary before fitting to set the jumper in order to activate the internal CAN bus terminating
resistors, or to set the switches (as from hardware version 3). Jumper set or switch on [ON] means:
terminating resistor connected.
Fig. 6: DIP switch ON = terminating resistor connected
The card can be fitted into any free PCI slot. Ensure that the PCI bus connector is making good contact, and
that the module is seated firmly. Secure the board to the PC slot housing with the mounting bolt.
