BC Biomedical DA-2006, Service Manual, Page: 148 / 171

C 2
Use the following procedure to verify the Unit Under Test (UUT) operation:
DEFIBRILLATOR INPUT TEST
1. Set DMM to measure resistance
2. Measure the resistance between the UUT defibrillator input plates. Resistance
should be 49.5 to 50.5
Ω
.
3. Connect the Calibration Interface Module to the UUT. (See the DA-CS-06 User
Manual for more information.)
4. Set the UUT for High Range input mode.
5. Use Defibrillator to discharge at energy levels of 100, 200 and 360 Joules. Verify
that UUT measurements are within tolerance (2% of the calibrator measurement)
as shown on the PC display.
6. Run the UUT self-test waveform.
7. Measured power should be 100 to 150 Joules.
8. Set the UUT for Low Range Mode.
9. Use Defibrillator to discharge at energy levels of 5, 20, and 50 Joules. Verify that
UUT measurements are within tolerance (2% of the calibrator measurement) as
shown on the PC display.
NOTE: If Input Overload Warning, use next lower setting on source defibrillator.
10. Run the UUT self test waveform.
11. Measured Power should be 4 to 6 Joules
VERIFICATION TESTS