Baxall ZMX/BD/10, Operating Instructions Manual

Page: 56 / 111

HBZMXSIB/10/16SD-PR-1 Page 55
The ENABLE set up mode is used to change disabled zones to enabled zones.
Enabled zones will sense motion, according to the sensitivity and the minimum target
size set for the camera. When this mode is selected, the zone which has the flashing
cursor will be changed to an enabled zone. The arrow keys
can be used to move
the cursor and enable as many other adjacent zones as necessary. Change the
mode to NO ACTION or DISABLE when no more adjacent zones need to be
changed.
The DISABLE set up mode is used to change enabled zones to disabled zones.
Zones which are disabled will ignore all motion. After using the ALARM key
to
select the DISABLE mode, the cursor and arrow keys can be used to disable as
many adjacent zones as necessary, exactly as was described above to ENABLE
zones.
Indications
To indicate whether each zone is enabled or disabled, enabled zones have a grey
“ ” indication and disabled zones have no indication inside the corresponding
grid position.
Press ENTER to exit the zone set up screen, and return to the Motion Detection
menu. All the changes will be saved as they are made. In the Motion Detection sub-
menu, you can then set up sensitivity for the same camera, or zones can be set up
for a different camera.
Setup - The Motion Parameters Menu
The three motion parameters, sensitivity, automatic increase in record rate on
motion, and output relays, are all chosen in a single menu table on a camera-by-
camera basis.
Select the Setup Parameters section of the Motion Detection sub-menu to set any of
these parameters. The Motion Detection Setup, Select Camera window will appear,
where you select the camera. Select the camera by using the arrow keys
and
pressing enter. This will display the activity parameters for the selected camera. For
example:
The Camera field displays the number of the selected camera and cannot be
changed. The Sensitivity, Record Rate and Relay fields are described below.
Activity Parameters Setup
Camera : 01
Sensitivity : 06
Record Rate : 4x
Relay Output : NONE
[CANCEL] [OK]
Main Motion Detection Setup Parameters