Baxall ZMX/BD/10, Operating Instructions Manual

Page: 107 / 111

HBZMXSIB/10/16SD-OP-1 Page 31
Alarm Indicators
There is on-screen display of an A in each corresponding cameo of multi-screen
displays and ALM, on any full-screen displays relating to cameras in alarm. The
indications will be flashing.
An additional indication, in the form of an LED, is provided on the front panel, under
the ALARM key. This LED will flash if any live alarm is active and has not been
cleared.
An internal buzzer will sound while any live alarm is active.
Alarm Latching
There are three ways of latching alarms, which may be selected via the menu. These
are:
1) Latched until the operator cancels it (Latched).
2) Not latched (Transparent).
3) Latched for a pre-set time (Timed Out).
Motion Indicators
Depending how your system has been set up, the indicator, M, may appear in each
camera scene on Monitor-A multi-screens whenever motion has been detected. The
indicator is not present on full-screen analogue displays. This motion indicator will
stay on each active camera’s display for at least 2 seconds after the motion has
ceased.
Videoloss
Indications
You get the indication, V, displayed in each affected cameo of the multi-screen
display and VDL on any corresponding, full-screen displays.
Videoloss Action In LIVE Mode
Monitor-A: If the camera is being displayed at the time that videoloss occurs, the
camera image will be frozen. However, if sequencing is in progress, the display will
be blanked when it is switched to a camera experiencing videoloss.
Monitor-B: Will be blanked while a camera with videoloss is selected.
Videoloss Action In RECORD Mode
When videoloss is detected, the affected camera is temporarily removed from the
record list, and the coded digital data recorded with each field will be updated to
indicate a videoloss situation on the affected camera. This videoloss status is then