Baxall ZMX/BD/10, Operating Instructions Manual

Page: 54 / 111

HBZMXSIB/10/16SD-PR-1 Page 53
Programmable Outputs
You can select one or both of the two output relays to be activated when motion is
detected. This can be set up separately in the menu system for each camera.
Motion Indicators
The indicator, M, will appear in each camera scene on Monitor-A whenever motion
has been detected. The indicator is not present on full-screen analogue displays.
This motion indicator will stay on each active camera’s display for at least 2 seconds
after the motion has ceased. The motion indicator can be turned on and off in the
menu system, via the Indicate Detection section of The Motion Detection menu.
The default setting is off.
Note
The primary purpose of the multiplexer is efficient video multiplexing and the alarm
handling and motion detection are secondary functions. National standards
relating to alarm equipment should be taken into account when choosing
equipment to use with the multiplexers, and in general the multiplexer should not
be the only alarm device on the site.
Setup - Enabling And Disabling Motion Detection On A Camera
The factory default setting is each camera has motion detection disabled when the
unit is first powered up.
The first action which should be taken by you with respect to motion detection during
installation, is to enable the cameras on which activity detection is desired. For
verification, turn on the ‘M’ indicator.
If motion has been turned on, but there is no M indication in the corresponding
camera’s display during motion on that camera, first check that the indicator display
is correctly turned on in the Indicate Detection option of the Motion Detector sub-
menu. If motion is still not detected, check the set up of the detection zones and the
sensitivity setting as detailed in sections Setup - Enabling And Disabling Detection
Zones and Setup - Setting Sensitivity respectively.
Setup - Enabling And Disabling Detection Zones
The 256 zones are arranged in a 16 x 16 grid. Each zone can be enabled or disabled
by you, via the menu system. The factory default is that all zones are enabled. Note,
however, that all cameras have motion disabled as detailed on page 52. This must
not be confused with enabling or disabling individual zones within the camera scene.
During set up, use the menu system to disable zones which may contain movement
that is incidental or not important. Incidental motion can include the possible
Main Motion Detection Enable/Disable Detection
Main Motion Detection Setup Active Zones